The Chibi Lights Starter Kit from Chibitronics is an interactive kit designed to introduce you to the world of paper circuits. Inside each Starter Kit is everything you need to set up simple LEDs, switches, and sensors with only a bit of knowledge on how electricity works and a little ingenuity! With this starter kit no soldering or sewing is required, simply peel each LED sticker and place them in specific areas designated in the included guide sketchbook and watch your creation glow.
Included in each kit are 12 individual LED stickers (6 white, 2 each of red, yellow, and blue), a 5 meter roll of copper tape to run conductive lines to your LEDs, two CR2032 coin cell batteries to power your circuit, two small binder clips for holding your battery in place, a swatch of conductive plastic to help create a simple sensor, and finally a Circuit Sticker Sketchbook to provide you with an introductory guide to using circuit stickers.
Chibitronics has done an amazing job of amassing their knowledge base, as well. In the Documents section below is a link to their educational Learn page which is filled with step-by-step tutorials, instructional videos, beginning and advanced projects, and more!
Note: Due to the requirements of shipping the batteries included in this kit, orders may take longer to process and therefore do not qualify for same-day shipping. Sorry for any inconvenience this may cause.
- 6x White LED Circuit Stickers
- 2x Red LED Circuit Stickers
- 2x Yellow LED Circuit Stickers
- 2x Blue LED Circuit Stickers
- 1x Copper Tape Roll (5 meters)
- 2x Coin Cell Batteries - CR2032
- 2x Small Binder Clips
- 1x Conductive Plastic Swatch
- 1x Circuit Sticker Sketchbook by Jie Qi